Designed for all types of 8 Cylinder vehicles.
Very lightweight, shock resistance, waterproofs plastic housing.
Intelligent with OBD option
Auto calibration and auto map correction
Gas injector heating and diagnostic
Valve protection
Real time diagnostic of components
Best calibration result with OBD connection
E400 8 Cylinder
The ECU is designed to exploit the chemical-physical characteristics of the gas fuel used in Otto engines while maintaining the level of emissions of the exhaust gas according to the original standard car. The connector used in Air 48 is automotive type 48- Poles . The connection to the engine signals, offers exceptional qualities of connective security and protection against water infiltration
The connector used in Air 48 is automotive type 48- Poles . The connection to the engine signals, offers exceptional qualities of connective security and protection against water infiltration
Aria 48-8 makes a diagnosis of all gas components in real time, displaying any faults on the switch. Through the software you can diagnose and intervene on these anomalies.
Aria 48-8 connects with OBD (On Board Diagnostic) of the vehicle by exchanging information and acting actively and instantaneously Gas System optimizing the carburetion and engine efficiency.
E400 is the result of years of experience in the injection gas management for phased sequential Multipoint 3–4–6-8 cylinder engines.
TECHNICAL DATA
| Supply Voltage: | 10 – 16 Volts CC |
| Working temperature: | -20 / + 105 °C |
| Power consumption: – stand-by (key Off): | < 20 mA |
| – no load ready to change (key On): | < 160 mA |
| Gas Injectors supported: | 2, 3, 4 |
| Injectors Impedance: | da 2 a 16 ohm |
| Lock-off load on single input: | 2 (Imax = 4A cad.) |
| Inputs for lock-off / Services: | 2 |
| Water temper. sensors supported: | 4,7 – 10 kohm |
| Gas temper. sensors supported: | 4,7 – 10 kohm |
| Pressure sensors supported: | 4+2,5 bar Absolute |
| Lambda sensors managed: | 0..5V – 1050 & 806 compatibles – 0..90 ohm (others on demand) |
| Lambda sensors managed: | 0-0,8 / 0-5 / 5-0 / 0,8-1,6 / 2,5-3,5 / UEGO |
| Lambda emulation: | possible for all managed type |
| Change-over Switch: | Pushbutton, gas level shown, operating led, ready-to-change blinking, diagnostics, Buzzer |
| Interface: | 4 poles AMP on the loom for custom USB or Bluetooth interface |
| Standard OBD protocols supported: | CAN H/L & ISO KL |
CERTIFICATIONS
- ECE 67R-01
- ECE 110R-00
- ECE 10R-03
KIT CONTENT
- 1 x ECU Unit with standard plastic box + back cover in aluminum
- 1 x “Intelligent” change-over switch
- 1 x pressure sensor type 4+2,5 Absolute
- 1 x standard loom CA0315
- 1 x fuse (7,5 A) and fuse holder bag
- 1 x shrink tube bag (4 cyl)
- 1 x Wiring diagram
- Packing: 1 box per kit, 120 box in a carton, 2 cartons per pallet (extra cost will be charged if 1 pallet per carton is needed
